What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 03.07.2025 07:20
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
There are two important concepts here.
This device then solves the entire problem.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
Anne Wojcicki’s nonprofit reaches deal to acquire 23andMe - TechCrunch
At one ohm, the resistor has a maximum of 1 watt power.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
2024–10–16 [ OO OLAOYE OYEBODE ]
NAR Existing-Home Sales Report Shows 0.8% Increase in May - National Association of REALTORS®
At least they know the answer if they wanted it.
2024–10–14 [Omar Gharbi Omar Gharbi ]
Barnstars:
How do you write a letter to your uncle who sent you money for your birthday outfit?
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
In schematic diagrams this is the symbol for a fuse:
He then describes Rainy Season and Lightning.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
An AC voltage/ current source, and an ac inductive load.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
[old diagram got deleted by accident]
Why do narcissists and especially covert narcissists always play the victim?
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
nine
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
Apple has already fixed iOS 26's biggest design crime - Creative Bloq
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
the problem then depends on "how fast does the fuse operate?".
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
I post the exact comment here.
5 tiny habits that can significantly improve heart health, backed by science - Times of India
It seems Mohan does not understand the difference between a comment and an Answer.
What does a fuse do?
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
There are three different concepts here that are getting confused.
A circuit breaker is similar, but is resettable.
(Dc diagram shown, AC is similar).
Here is a simplified AC power diagram.
The third is lightning and “how it gets conducted into a home.”
eight
This is 'the assistant's answer'
He then describes the function of a fuse.
The MOV will conduct when the voltage exceeds 50% of line voltage.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
The bolt then partially travels down the line to your home.
He then asserts :
But it can get overloaded, and no longer works.
But… the neutral is now “floating” because of the 1 ohm resistance.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
It also is a device that limits the change in current flow.
Upvotes:
so, what happens?
a photo is worth a thousand words.
what exactly is a ‘surge’ protector?
This is the picture of an electronic coil of wire wound around a core of magnetic material.
A fuse is a non-resetable over current circuit protector.
This is where the MOV conducts again, and dissipated the energy.
One
Edit 2024–10.
but I think this circuit , shows a few more pieces.
Now when you have a certain ac resistance, then a current flows in a loop.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
These devices are installed between the “hot” and “neutral” and protective ground.
[image of Common-mode choke]
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
One is “what exactly is in a ‘surge protector’ ? ”
For this case there are devices called Metal oxide varistors (MOV).
The other is “what does a “fuse” do?”
2024–10–10[John johnson John Johnson ]
These are simplified answers to the original question, and does not change anything I wrote above.
First Sentence:
What is lightning?
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
This one hit behind the barn.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
So, the voltage could go up to 500 volts, and the fuse will not open up.
This is where this question deviates from being a 'generic' question, and becomes more specific.
Because the load is inductive, the current lags the voltage.(by a bit).
but this device (an Inductor) … impedes the rapid changes in the current.